[sdiy] Simple Power supply Part 2

[Pat Kammerer]

Okay...

I tried the supply with a load, between 470 ohm and 4.7k, and still the
ouput is about 15v DC.

I replaced the large 2200uf cap (filter cap?) with a new old stock cap which
seemed to test okay, and still the ouput is 15v DC.

I replaced the bridge rectifier with a new one with the same specs, and
still the output is 15v DC.

So I'm getting frustrated being this stumped on such a simple circuit...  I
must have some stupid mistake in there somewhere...

If one of the .1uf ceramics was bad would that destroy the regulation so as
to end up with ~15v instead of 9v?

I suppose I should just start from scratch from a different schematic or
something, but this one seemed so basic...

Thank you all for your help and insight.
I love building, I just wish I was better at it...
Pat