[sdiy] HP 202C Low Frequency Oscillator

[Glen]

At 11:56 PM 7/5/04 , Colin Hinz wrote:

>I did try my (perhaps inadequate) metric set, but those didn't fit
>either. I wasn't terribly surprised, considering that the gear in
>question is American-made from the 1950s.

If absolutely all else fails, you can use a tiny screw extractor, but you
will have to find a new set screw after that operation, and possibly a new
knob as well. I've had to drill out set screws and use screw extractors on
them before. I usually don't have to replace the piece the set screw was
located in (a knob in your case), but I could conceive of situations where
this *might* happen.

good luck,
Glen