[sdiy] PCB Issues

[peff 2cv]

Hi,

I use the free software from PCB express. Yes, you have the option to have 
PCB express make very nice boards relatively fast and cheap. Too expensive? 
then use the PCB software, print it out on glossy photo paper and iron it to 
a piece of copper clad board, etc. Details are here:

http://www.fullnet.com/u/tomg/gooteepc.htm

I tried this recently and had good results. It takes a time or two to get 
the hang of it but quite cheap and easy, all things considered.

HTH

Peff

>From: s <sk0za at yahoo.com>
>To: synth-diy at dropmix.xs4all.nl
>Subject: [sdiy] PCB Issues
>Date: Sun, 19 Dec 2004 23:14:53 -0800 (PST)
>
>Hello everyone- my first question to the list is 2
>part, I guess.
>
>I have a pcb that I need to have made- it's 4x6, and I
>have a graphic of the layout.
>
>Do any of you make PCBs from such graphics (for pay,
>of course!)
>
>---
>
>I was thinking I could lay it out in PCB software, and
>then send the gerber file to a manufacturer and have
>it made that way. Expensive, but I'd get a nice board.
>The problem is, I do not know of any software to use
>for such activities. DO any of you have any
>recommendations? I looked into eagle, but the board is
>too large for the lite version.
>
>Thanks for your time! this is getting to be a bit of a
>headache...
>
>S
>
>
>
>__________________________________
>Do you Yahoo!?
>Meet the all-new My Yahoo! - Try it today!
>http://my.yahoo.com
>
>