[sdiy] A few Oberheim questions

[Colin f]

> 1.  I have a request to make the editor also support the
> Matrix 6/6R synths.

There's a major problem with the Matrix 6 sysex (don't know if it applies to
the M1000 too) I found out about when I created a Doepfer Drehbank profile
for a friend.
There are some parameters on the M6 that can take a positive or negative
value, but the individual parameter edit sysex only supports setting
positive values. To set a negative value, you need to send the whole patch.
I've used the OB6000 editor in the past, and remembered there being
occasional nasty glitches when certain parameters were edited, and I think
this maybe explains it.
Just so you know...

Cheers,
Colin f





________________________________________________
Message sent using UebiMiau 2.7.2