[sdiy] 4 or 5 U blank panels

[Julian]

When i eventually recieve my new efm boards, and will be looking for blanks,
im going to get them from a company that does sheet metal for stuff like
tropy name plaques, and office door nemes, etc.etc.

I know of such a company in my country (england) but they must be pretty
common.  Theyll cut to within 1mm in various metal types.

Alternativly, ive had stuff cut at my local metal fabricators before.  Ive
never specified that i need the finish to be good (its not been for
faceplates) but i suspect that if i did so, then they could take the time to
make sure it stays unmarked.

Guilitine cut, rather then saw cut, is what your lookign for if you go down
this route.

Cheers, Julian


----- Original Message -----

> Hi,
> I am looking for 4 or 5 unit high blank panels, prefarbly in different
> widths,  for my future modular. What is a good place to get them? The 3
and
> 6 high panels are widly available but the 5 high units seem to be only
> available at modular manufacturers.
> Thanks,
> Maarten
>
>