[sdiy] FracRak panels

[Chris Williams]

Quoting from the archives (and the measurements fit perfectly for
mine)...

===============================================================
The Paia frac-rac faceplates are 5.25´´ tall and multiples of 1.5´´
wide. (a 
1U is 1.5´´, 2U is 3.0´´, etc) 

The holes are .75´´ from the panel´s edge (horizontally) and 5/16´´ from
the 
top or bottom of the panel. A 1U panel has one hole on the top/bottom. A
2U panel has 2 holes on the top/bottom 1.5´´ apart, the 3U also has 2
holes, 
and they´re spaced 3.0´´ apart 

Sorry for the measurement in inches... 

Dave Magnuson 
=========================================================

HTH

Chris.


On Fri, 2003-11-28 at 22:29, Brice D. Hornback wrote:
> I'm looking for the same thing.  I have both a 1U and a 2U panel designed...
> but would like something to compare it to so I get the mounting holes in the
> right places.  :-)
> 
> Thanks!
> - Brice
> http://www.SynthModules.com
> 
> ----- Original Message ----- 
> From: "Tom Arnold" <xyzzy at sysabend.org>
> To: <synth-diy at dropmix.xs4all.nl>
> Sent: Friday, November 28, 2003 4:46 AM
> Subject: [sdiy] FracRak panels
> 
> 
> > Does anyone have a FracRak panel they have layed out in Front Panel
> > Designer that I could look at?  Preferably one you've actually had
> > made.
> >
> > -- 
> >  ------------------------------------------------------------------------
> >  - Tom Arnold -       When I was small, I was in love,                  -
> >  - Sysabend   -       In love with everything.                          -
> >  - CareTaker  -       And now there's only you...                       -
> >  --------------         -- Thomas Dolby, "Cloudburst At Shingle Street" -
> >
> 
>