[sdiy] ASM-1 VCO

[Brett, Bill]

Greetings,

I have built up several ASM-1 PCB's and the VCO pulse width modulation control does not work as I would like. A control signal from an LFO will sweep the PWM control until the square wave output goes to the power rails. There is only a narrow range in the middle of the control signal swing that results in a square wave output. I also used a 100k pot to set the PWM manually This control also has a very narrow range (about 15%) that results in a square wave output before the output goes to either of the power rails. 

Does anyone have advise about modify this part of the VCO so that either control does not shut down the square wave output. 

Thanks

-Bill

-----------------------------------------
This message (including any attachments) may contain confidential information intended for a specific individual and purpose. If you are not the intended recipient, delete this message. If you are not the intended recipient, disclosing, copying, distributing, or taking any action based on this message is strictly prohibited.