[sdiy] Peltier Elements

[ASSI]

On Tuesday 13 May 2003 13:33, Czech Martin wrote:
> Condensation is a big point, for Thermostream experiments
> at -40C I had lot of icing problems (outside the stream).

You also get ESD problems inside the stream unless you ionize the air...

> The question is also how low the temperature must be.
> If the curves to be observed would be linear with little
> deviation, it would be enough to mesure at 25C and 55C
> to get a good aproximation of what's going on.

I think 10/40/70°C would be quite useful and not too difficult to 
achieve.

Never forget: If you want to prove a linear dependency, make no more 
than two measurements. ;-)



Achim.
-- +<[ Q+ & Matrix-12 & WAVE#46 & microQkb Omega sonic heaven ]>+ --

Q series MIDI Implementation & additional documentation:
http://homepages.compuserve.de/Stromeko#WaldorfQDocs