[sdiy] Signal indicator board...

[Peter Cornell]

Hi there

I have a version of Grant's cct on my site. It has a simple half wave
rectifier conditioner with a 4 LED meter.

http://1176neve.tripod.com/1176/id12.html

Jurgen Bergfors (Bergfotron) also has a simple signal/overload indicator.

Regards
Peter

----- Original Message -----
From: "Grant Richter" <grichter at asapnet.net>
To: "Tim Ressel" <madhun2001 at yahoo.com>; "Synth-Diy"
<synth-diy at dropmix.xs4all.nl>
Sent: Friday, May 02, 2003 7:20 PM
Subject: Re: [sdiy] Signal indicator board...


> This may interest you...
>
> All the VCAs in the Wiard modules use an LM339 quad comparator chip to
form
> a 4 section VU meter. Like an LM3916, but with only 4 sections. An LM339
can
> be found as cheap as $0.29 each (quant. 200) whereas an LM3916 runs around
> $2.00.
>
> Use a resistor divider like this:
>
> +15V 5.1K 6.8K 2.2K 680 330 Gnd
>
> This gives you (roughly) reference voltage levels of 10V, 3.3V, 1V and
0.33V
> which correspond (again very roughly) to levels of +20, +10, 0 and -10
dBv.
>
> Ideally, this should be a bi-polar circuit with an absolute value circuit
in
> front of it. So you indicate both positive and negative waveform peaks. If
> you make the simplifying assumption that audio waveforms are ALWAYS
centered
> around 0 volts, you can ignore the negative peaks, and eliminate the 2
> additional op-amps needed for the absolute value circuit.
>
> The 10 volt level corresponds to 20 volts peak to peak and is a clipping
> warning. LED colors I used are Green, Green, Amber, Red for -10, 0, +10
and
> +20.
>
> Tie the 4 negative comparator inputs together and to a 100K to ground, use
> as an input (high impedance). Run the reference levels to the positive
> comparator inputs. Connect the LEDs with current limiting resistors
between
> +15 and the comparator open collector outputs. 10 resistors, 4 LEDs, 1
chip.
>
>
> > From: Tim Ressel <madhun2001 at yahoo.com>
> > Date: Fri, 2 May 2003 09:00:53 -0700 (PDT)
> > To: Synth-Diy <synth-diy at dropmix.xs4all.nl>
> > Subject: [sdiy] Signal indicator board...
> >
> > Yo,
> >
> > I've been thinking (dangerous, I know) and I think
> > what the world needs is a little board that takes in a
> > signal and has two LEDs to show signal present and
> > overload. This makes a handy visual indicator as well
> > as a swell panel filler. Real simple circuit, possibly
> > surface mount to keep sizes small. It could be
> > single-supply to keep wiring down.
> >
> > So like, what do ya think??
> >
> > --Tim
> >
> > __________________________________
> > Do you Yahoo!?
> > The New Yahoo! Search - Faster. Easier. Bingo.
> > http://search.yahoo.com
> >
>
>