[sdiy] power one HAA15-0.8A supply

[Benjamin Riggs]

was on the site earlier, but missed that one.

cheers.

----- Original Message -----
From: "Ullrich Peter" <peter.ullrich at kapsch.net>
To: "Benjamin Riggs" <benj at iinet.net.au>; "Synth-Diy"
<synth-diy at dropmix.xs4all.nl>
Sent: Wednesday, July 09, 2003 11:05 PM
Subject: AW: [sdiy] power one HAA15-0.8A supply


>just picked up one of these removed from old equipment. its a dual rail
>supply, but has 7 output terminals, 4 of these being for sense. i know
these
>are used by a few on the list.
>
>my question is, how do i wire up the sense terminals, or do i just leave
>them unconnected?

Normally you connect the sense terminals to the output terminals
at that point where to voltage should be exactly the nominal voltage (i.e.
the point where the output voltage is compared against a reference voltage).
Normally this is the input connector of your system that has to be powered.

Leaving this lines open could eventually lead to uncontrolled output
voltages
and so destroy your circuit connected to the supply.

Read more about it here:
http://www.power-one.com/technical/remote.html

Ciao
Peter

        \|/
       (o o)
--oOOO--(_)--OOOo------------------------------------------------------
                   Ing. Peter Ullrich   mailto:peter.ullrich at kapsch.net
                   Homepage: www.ullrich.at.tt , http://come.to/ullrich
                   As of 1st of February there are new numbers:
                   Phone: +43 (0)50 811 2265   Fax: +43 (0)-50 811 2209
                   eFax:  +43 (0)50 811 992265
   .oooO           Hardware & Software Developer /  Electronic Musician
   (   )   Oooo.   Kapsch TrafficCom AG                 Vienna / Austria
    \ (    (   )   http://www.kapsch-trafficcom.com/
-----\_)----) /--------------------------------------------------------
           (_/

This e-mail and any attachment and the included information are
confidential,
protected by copyright and intended solely for the use of the named
recipient(s). If you are not the named recipient any disclosure, copying,
distribution or retention of this e-mail is prohibited and may be unlawful.
If
you are not the intended recipient, please inform us immediately, delete
this
e-mail and all attachments from your system, and refrain from taking any
other
action in reliance to this e-mail.