[sdiy] RE: [AH] Analogue Sys. RS300 CV to Midi - 1stImpressions

phillip m gallo philgallo at attglobal.net
Fri Aug 15 11:59:43 CEST 2003


Peter,

Replied to soon,
For the dual channel assignment to work you would have to subtract the top 7
bits of the channel one CV prior to input into channel two.  Still, more
often than not, the 7 bits of quantization open up a lot of configuration
and combinational possibilities otherwise not easily achieved. 10 points for
this module.

regards,
p


-----Original Message-----
From: Peter Grenader [mailto:peter at buzzclick-music.com]
Sent: Friday, August 15, 2003 2:48 PM
To: philgallo at attglobal.net
Cc: synth diy
Subject: Re: [sdiy] RE: [AH] Analogue Sys. RS300 CV to Midi -
1stImpressions


phillip m gallo wrote:

> Can you assign as single input voltage across a pair of MIDI Controller
> Coarse and Fine message types?  For instance Breath Controller number 2
and
> 34 (dec)?


Yes...and no.

Only one assignment per input channel.  But...you've got eight inputs.  So
to do this, one input would used for the breath controller and the other
would have the same input signal, but assigned to 34 instead of 2.


---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.510 / Virus Database: 307 - Release Date: 8/14/03

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.510 / Virus Database: 307 - Release Date: 8/14/03



More information about the Synth-diy mailing list