[sdiy] DSP reverb ideas?

[Karl Dalen]

I have been using both the 3201 and the 3101 for a while,
the single chip reverb are nice somewaht limited internal
ram but quite adequate for many high end reverb algos.

Besides the reverb IC have a remakable simple instruction
set wich you dont get with a MOT or TI DSP. You write 
directly in assembler, a multi tap delay takes just 
some minutes to do. The propulsion people are nice
and easy folks to deal with.

Alesis has free tools for their IC's you can down load
them from their web site. I "could" say that this is the 
closest a diy dude can get decent DIY reverb!

Writing a good sounding reverb algorithm is "NO EASY TASK".
KD

Kevin Downs <kdowns at optusnet.com.au> skrev: > Well, the TI parts may bit a
bit cheaper, but the time, effort and skill
> required to produce the equivalent of the Alesis FX code is fairly
> staggering.  Even if you were adapting open source code, the sheer
> number of hours you would spend debugging would completely swamp the
> price difference.
> 
> Regards,
> Kevin
 
> > -----Original Message-----
> > From: owner-synth-diy at dropmix.xs4all.nl 
> > [mailto:owner-synth-diy at dropmix.xs4all.nl] On Behalf Of Bert 
> > Schiettecatte
> > Sent: Thursday, 21 August 2003 8:23 PM
> > To: synth-diy at dropmix.xs4all.nl
> > Subject: RE: [sdiy] DSP reverb ideas?
> > 
> > 
> > Maybe i'm missing something here, but why would you spend 8 
> > EUR on a DSP and 2.5 EUR on a DAC or ADC if Texas instruments 
> > gets you a more powerful DSP for 5$ and a 24-bit 96kHz 
> > ADC/DAC for around $1?
> > 
> > bert
> > 
>  

Yahoo! Mail - Gratis: 6 MB lagringsutrymme, spamfilter och virusscan. Se mer på http://se.mail.yahoo.com