[sdiy] Can I get an opinion here?

[Tim Ressel]

Hey all,

I know you all are the silent type and don't really
like to speak your mind  ;-)  But I need some help
here. I have come into a little money here and have
decided I can afford to have a run of PCBs done. Not
much money, just enough for one board. 

So here is what I have in mind: The most needed module
(and the hardest to hand-wire) is the VCO. I use
WinBoard and am limited in pad count. I can get the
expo convertor and saw oscillator part on one board.
That would leave sig conditioning for other waveforms.
This is kool for when you need lots of saw only
oscillators.

Specs: expo/linear in, soft/hard sync in, 0-5V saw
out.

So like, how far off base am I here? 

--Tim

__________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.
http://search.yahoo.com