[sdiy] 76477 "N" vs "NF"

[Bobinvertedsdiy at aol.com]

In a message dated 11/19/2002 8:06:16 PM Eastern Standard Time, 
john at blacet.com writes:


> 
> Thanks to everyone for all the suggestions!
> 
> Unfortunately the .070 pitch looks a lot more like SMT than DIP. I would
> hate to solder anything to those pins. If I had to, I would bend up
> every other pin to give some room for soldering.
> 
> The difference in width from the "N" to "NF" is only 0.2", leaving only
> 0.1" on each side to run traces if you were going to design an adaptor
> board. It would have to be doublesided and it would be a challenge.
> 
> I guess these go back to the vendor.
> 
> Anybody want 100 brand new shiny 76477NF?
> 
> Regards,
> --/////--
> John Blacet
> Blacet Research
> http://www.blacet.com
> 
> 

Anybody want 100? Probably not, but I'm sure there are quite a few people who 
would like one or two. Would you consider selling them individually at a 
small profit? 

Robert 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20021119/cff8904e/attachment.htm>