[sdiy] PCB production costs

[David Reichert]

>From looking around myself, they can be had for C$70 tooling, C$30 for
each after. This is one place that was particularly low, most in Canada
seem to be in the same range as in Australia, maybe a bit lower as the
$C is a bit higher valued than the $A (at least for now).

-----Original Message-----
From: owner-synth-diy at dropmix.xs4all.nl
[mailto:owner-synth-diy at dropmix.xs4all.nl] On Behalf Of Trevor Page
Sent: March 7, 2002 2:09 PM
To: synth-diy at dropmix.xs4all.nl
Subject: [sdiy] PCB production costs

Hi all.

I'm asking this to members of the list out of curiousity:

Where you live, how much would you expect to pay for a very good quality
printed circuit board, double sided and silkscreened, measuring
something
like 200mm by 150mm, including the initial tooling costs, and assuming
quantities of 20 to 30?

I'm not really looking for any particular company recommendations -
rather
I'm just wondering how production costs might vary in different regions.
Just after rough figures.

Regards,

Trevor.



--
trevor at resonance.fsnet.co.uk