[sdiy] Passive debouncer

[Peter Grenader]

I'm trying to use a mechanical switch as an option to advance a sequencer
count (manual tuning).  I'm getting about 15 million steps for each touch of
the switch due to it bouncing.  I don't want to run this into an active one
shot, for reasons I don't need to go into.  Was hoping I could make a real
simple passive rc on the faceplate, at the switch itself, to take care of
it.  Tried hanging one at the wiper of the switch, didn't work.  POssibly my
values didn't cut it.

any suggestions?

thanks in advance,

Peter