[sdiy] Korg schematics

greg montalbano greg.montalbano at ucop.edu
Thu Apr 18 22:09:16 CEST 2002


As far as I can see from my poor-quality xerox of the 8000 manual, it's all 
+/- 5volts -- no idea if it can be run at higher voltages.

~G
"In Maestra's foyer Switters was greeted by a doctor and a lawyer.  Does
it get any worse than that?  Assuming no decent person would allow a
land developer in their home, only the presence of a cop and a priest
was required (the Four Horsemen of the Apocalypse) to complete this
roll call of 
damnation." 
Tom Robbins, FIERCE INVALIDS HOME FROM HOT CLIMATES
At 12:25 PM 4/18/02 -0700, you wrote:
>Hello all -
>
>Looking for schematics for a Korg DW-6000, 8000, or DSS-1/DSM-1
>
>Need to know supply voltages for Korg 2069 chip. (I know about the 
>Poly-800, it is
>running off of +/- 5v... I want to know if it will run off of +/- 15v...)
>
>Any help would be GREATLY appreciated! :)
>
>
>
>BTW, if anyone needs a copy of the Korg770 schematic, I have a VERY clean, 
>legible copy
>in both a "C" size drawing (at least I think that is the size) and in .gif 
>format
>(~1.2MB)
>
>It is DEFINITELY an "odd" synth... I still cannot figure out the 
>CV/gate/trigger setup
>on it...
>
>                         -Duane
>--
>
>
>        "A word to the wise ain't necessary. It's the stupid ones
>                            who need the advice."
>                         - Bill Cosby
>                       ________________________________
>                      / o o oo              o ooo o   /\
>        -------------/ ////  Duane R. Balvage   //// / /---------
>                    /    _________________________  / /
>                   / // / // /// // /// // /// / / / /
>                  /___ //////////////////////////_/ /
>                  \____\________________________\_\/
>
>                      Intel Corporation, RA2-455
>                    Portland Technology Development
>        =========================================================
>
>               Phone: (503) 613-8055    FAX: (503) 613-6143
>                   E-Mail: dbalvage at ptdcs2.ra.intel.com




More information about the Synth-diy mailing list