[sdiy] Replacement for 2N4391

[Chris Crosskey]

I've used 2N3819's in the same circuit (the Modulus VCO is a straight clone
of the ASM-1) and they worked well. but the pinout is different so you have
to sort of twist it around.....You might try Transonics if you are in teh UK
(can't remember contact details but htey sould be on the web)....they've
been a good source for stuff for me in the past, though you might ahve to
buy rather a lot to get a few IYSWIM...

chrisc
> 
> 
> Flo,
> 
> You might check with http://www.reichelt.de/ - they have them 
> ( EUR 1,20 )
> and are quite a good ( cost effective ) source for any type 
> of electronic
> components needed.
> I do believe that they require a minimum order of 10 EUR (from within
> Germany).
> 
> Gert
> 
> ----- Original Message -----
> From: "Fortner Florian" <florian.fortner at fh-joanneum.at>
> To: <synth-diy at dropmix.xs4all.nl>
> Sent: Monday, April 01, 2002 12:54 PM
> Subject: [sdiy] Replacement for 2N4391
> 
> 
> > Hi List,
> >
> > Short question: Is there an equivalent for the 2N4391 Fet? 
> (used in the
> ASM
> > VCO) because the original seems hard to get hold of here in Europe.
> > Perhaps the BS250?
> >
> > Any help would be appreciated!
> >
> > regards,
> >
> > flo
> 

This e-mail, and any attachment, is confidential. If you have received it in
error, please delete it from your system, do not use or disclose the
information in any way, and notify me immediately.