[sdiy] how to hook up scope to patchbay

[Scott Bernardi]

You could use a BNC "T" connector, which has three BNC connectors. Put one in the
scope input, one through a BNC cable to the patchbay, and the probe on the other.

markus wrote:

> i have an old Tek465 scope with 10X BNC-connector probes. i would like to
> integrate it into my patchpay for viewing signal phase correllations and levels
>
> what cables do i need to connect it to the patchbay for this purpose ?
>
> i assume i would need to disconnect the above wires going to the patchbay
> at the scope end and reconnect my probes whenever i wanted to ...probe.  is
> there a way to have the probes hooked up AND wire it to the patchbay
> simultaneously ?
>
> mark

--
Scott Bernardi
sbernardi at home.net