[sdiy] Where to have PCBs made in the US?

[Jim Patchell]

    The best place I know of that I have used is Advanced Circuits, BUT!
you may have a problem.

    Most PCB places require the following:

    Gerber Files
    Drill Files

    The drill files might be your biggest headache.  Everything must
match perfectly for them to make boards.

    By the way, I am expecting the first batch of boards from them using
their $33 each deal (which is really good if you only need a couple of
boards).

    Anyway, take a look at http://www.4pcb.com

    -Jim

kpeek1 at prodigy.net wrote:

> I have been working on the Elektor Vocoder PCB files
> from a website I found. I am almost done cleaning up
> the pcb files in Bitmap form.
>
> Where can I get a small run made of the PCBs?
>
> The run would be:
>
> Bus Boards: 2
> Input/output Board: 1
> Power supply board: 1
> BPF Boards: 10
> Noise Board: 1
> Detector Board: 1
> Switch Board: 1
>
> As you can see. I would need several different board
> runs.
>
> I would at least like to get the BPF boards done. I
> could always perf board the others.
>
> Thanks!!!
> Kevin Peek