[sdiy] physical modelling

[GothGeek Sysadmin]

On Mon, Nov 12, 2001 at 08:00:57AM -0500, Glen wrote:
> It's too bad that no one has heard an all-tube BBD, to make sure the simulation
> is accurate. Then again, maybe that's an advantage for whoever writes the
> simulation. No one would be able to tell him it doesn't sound enough like the
> real thing!  :)

I have 10 stages built and "working"  Definatly some issues to be ironed out
here and I wont be able to spend any quantity of time on it again until 
thursday.  Dropping a scope on the inout and output I can definatly see a
delay and the waveforms look vaguely simular.  I have cheated quite a bit
I think by not clocking it with tubes, but the sample&holds are all tube so
the audio path is 100% tube.  Building past 10 stages however may be more
then my sanity can handle.  If I thought wiring a synth front panel was
time consuming... that was about 30 hours of point to point wiring.  That
and I need roughly another 950 6112's and a power supply the size of a 
volkswagen. ( common sense is kicking in... )

 -Tom

-- 
 ------------------------------------------------------------------------
 - Tom Arnold -       When I was small, I was in love,                  - 
 - Sysabend   -       In love with everything.                          -
 - CareTaker  -       And now there's only you...                       - 
 --------------         -- Thomas Dolby, "Cloudburst At Shingle Street" -