[sdiy] Urei 1176

[Lincoln Fong]

I have one of these. I have a few notes I made based on measurements I made
when fixing/setting it up- not from a service manual but it works fine and
the threshold was not changed from when I got it.
It starts: 'Adjust Q1 bias preset (R81- the one whose wiper is connected to
the release control) so wiper is minus 2.6V with no input signal'

I also have a 2 sheet circuit description (very basic and no
voltages/adjustment values) but I can scan if anyone wants it. I notice that
someone has posted the schematic and low noise mod on a website which I'm
sure I could find again.

Lincoln

-----Original Message-----
From: owner-synth-diy at node12b53.a2000.nl
[mailto:owner-synth-diy at node12b53.a2000.nl]On Behalf Of mark verbos
Sent: 31 May 2001 10:10
To: synth DIY
Subject: Re: [sdiy] Urei 1176


Edu Silva wrote:

> Hi, JH
>
> "jh." wrote:
> >
> > is anybody familiar with the Urei 1176 compressor ?
> > Any hints for which threshold voltage Q1 is selected ?
>

Did an answer come out for this? I always kinda wondered what would make
a good replacement part....

--
mark verbos

"if you want something done right, build it yourself."

www.simple-answer.com

watch out for...
on my label SIMPLE ANSWER "White Enamel" Simple Answer 005 out now,
distributed by Integrale, UK