[sdiy] power transformer pointer ?

Mountain Man mtman at cloud9.net
Fri May 25 02:02:08 CEST 2001


Ohhhhhh  :(   That's disappointing.  I do hope I can find a replacement
transformer, I'd hate to have to ditch my Xpander because of lack of that
single part  :)    The specs of the transformer appear from the schematic and
manual as follows:  single primary winding that takes 13V at 30 Khz.  The
secondary is tapped, rectified and filtered to produce 2 +55V outputs, + and
- 12V, +5V (-5V is a feed off the -12V), 2 grounds, and 2 9VAC outputs, a
total of 9 outputs from the secondary.  Any idea of where to look for
something like this?   ANY pointers, no matter how vague, are welcome at this
point.

Thanks,
Elby


patchell wrote:

>     A lot of time, power transformers in comercial equipment are custom
> made.  Even if you locate the manufacturer, you more than likely won't be
> able to get one.  Your best bet is to find out what the old one did
> (voltages, etc), and find something as close as posible.  12 pins doesn't
> sound good.  It probably has two secondaries, with center taps, and two
> primaries, with 0-100-120 taps.  If this is the case, your chances of
> finding something are greatly reduced.  I don't know why, but those kinds
> of primaries are difficult to find on off the shelf transformers (not
> imposible, just difficult).  Sorry to sound so pesimistic, but finding
> just the right transformer is always such a pain.
>
> Mountain Man wrote:
>
> > I need to replace a power transformer in my Xpander.  The transformer
> > has 12 pins, and written on it are the numbers "661023"  and  "51420".
> > The service manual says: "power xfmr 30 Khz 8103-TI incon"   I did a
> > search for "incon" and located a company called "Intelligent controls"
> > that makes power reliability equipment - but don't appear to mfg
> > transformers.  None of the electronics places I tried (Mouser, Allied,
> > Newark, Digikey) have Incon in their manufacturer lists.  Can anyone
> > give me a pointer on where to locate this part?
> >
> > Thanks,
> > Elby
>
> --
>  -Jim
> ------------------------------------------------
> * Visit:http://www.silcom.com/~patchell/
> *-----------------------------------------------
> *I'm sure glad Merry Christmas comes just once a year
> * -Yogi Yorgensen
> ------------------------------------------------




More information about the Synth-diy mailing list