[sdiy] shielded wire recommendation

[DCMagnuson at aol.com]

Hi everyone,

I've gotten a list together of the mods I want to perform on my SH-101.  I'll 
be adding VCF inputs, VCO outputs, and a VCF overdrive pot that will require 
passing the audio signal up several inches of cable to new pots / jacks... so 
I decided to buy some cable for it (1 conductor + shield).  I stopped by 
Radio Shack, and bought a small spool, but the wire they carry is very poorly 
made.  It's hard to work with, and not very flexible.

Does anyone have a "favorite" sheilded wire that they use?  I'd prefer 
something available through Mouser or Digikey, as these are the suppliers I 
use most often.  Since this will be internally mounted, I suppose foil shield 
with drain will be fine (smaller diameter is a nice benefit)

Also, is there any benefit to using this shelided cable on ALL of my 
modifications?  I wasn't sure if there's a need to shield CV inputs / outputs 
as well.

Thanks in advance

Dave Magnuson