Hard sync on OSC's

[Rob Zero]

It looks like you will need to differentiate a saw wave with a simple cap in
line with the signal, then run it into an inverter with its normal output
set to 0v.

Rob

----- Original Message -----
From: Gerry Dahl <gerryd at ntx-tech.com>
To: synth diy <synth-diy at node12b53.a2000.nl>
Sent: Monday, May 01, 2000 1:13 PM
Subject: Hard sync on OSC's


> Hi Everyone,
> I have a project that needs the OSC's to hard sync. I have 2 CEM3340's
> and I see that pin 6 is the hard sync input but I want to know what
> supporting
> circuitry I'll need to connect these 2 OSC's together.
>
> Thanks.
> Gerry Dahl
>
> Keep On Moogin'
>
>