mux address/enable

[Jim Patchell]

    If I was doing it, I would disable the mux "before" changing the
addresses, just to be on the conservative side (or in other words, hold
addresses constant while changing the enable bit).

    -Jim

Roel Das wrote:

> Hello everyone,
>
> I'm writing software for my midiCV. And I have yet another question!
>
> When you send a new address to the mux (max336 or dg506 in this case), can
> you enable the mux at the same time, or do you have to wait?
> Same for disabling the mux. Is there a problem if I always disable the mux
> by sending out a zero to all the address lines and the enable line? or
> should I make sure that the address stays the same when I disable it?
>
> Thanks,
> Roel
>
> BTW, a preliminary version of the software will be available at my website
> this week, and the complete text for my thesis in dutch. (Final version, I
> have to hand them in on wednesday...)
> www.geocities.com/roelrules/