behringer mixingdesk modification.

[Reverend djbluE]

Dave Krooshof wrote:


> The problem is how to find the spot on the board you can tap into.
> You might be so lucky to find a jumper.
> Do you have a blockdiagram for the desk?

No I do not.  I was just planning on soldering a wire to the back side
of where the signal enters the channel fader, and running that wire to
the FX send pot(s), and possibly (probably?) cutting the original
trace that sends the post-fader signal to the FX pot.  I guess adding
a little pre-post switch would be nice too, but the board is pretty
tiny, although I have seen some really tiny switches. hrmm...
-ben