behringer mixingdesk modification.

[Dave Krooshof]

>the inputs can be send to any of two external FX sends, but only if
>the fader for that input is up; the fader controls the over-all level
>that gets sent to the FX out.  Would this be a post-fader send?
Correcto.

> My
>old board had pre fader sends, which was much better I thought,
It depends on what you want to do, as typically, you want to fade your
reverb aswell as the direct signal, to name one purpose. But if you want
more then two outputs on a desk, you need prefader sends.

>Maybe I could just take the
>signal path and split/jump it from just before the channel fader and
>route it to the FX send?
Exactly my wish.

I did find the soldering points on the board, which was easy in my case, as
the board seems to be made to modify for this matter.

>Doesn't seem too hard I think, but I'm
>probably missing something huge here.
The problem is how to find the spot on the board you can tap into.
You might be so lucky to find a jumper.
Do you have a blockdiagram for the desk?

Dave

--------------------------------------------
Dave Krooshof http://www.xs4all.nl/~krooshof
geluidstechnicus @ http://www.ahk.nl/the/theatertechniek_ov.html
webmaster: http://www.popronde.nl