Power Supplies

[J.G. Wong]

Hi,

	I just got a couple of those power supplies that the Mac Doc and Harry
told me of from MPJA. Before I put it in my Ultraman luchbox I would
like a little guidance on approach.

	I saw the line cord has eyelets on it and the two power taps have a
very familiar looking connectors on them. What are they?  
	
	Wanting to put one in a largeish cabinet I thought that just putting a
turnaround on the 2 +-15v outputs and running it to either a Blacet or
MOTM distro board would be a good way to go since it is already set up
and solidly so. I also thought that cutting the AC cable and running it
to an IEC rf filter / inlet and a lighted switch. 

	Is this sufficient to set this up to power 20 average modules.  Are
there any other protection schemes that I should consider to make my
boards safer.  Years ago I used a lot of Tantalum caps because of  the
instructions on my EMU evaluation cards, I ended up with a lot of
problems and i could never really decide if it was those bypass caps or
my 723 power supply.

	If enough people get these supplies I'll sut up the best setup schemes somewhere.

G. Wong (fiveman)