Paia power supply

[James Damewood]

Yes, if you are using the 9700 midi2CV.  Just connect the +/-15v  supply 
between D3 and R51 on the positive side.  The negative side connect
between D4 and R52.  Of course ground is attached to point "G"

Option: Remove the power switch and replace with a normal open push button.  
Connect one leg between C1 and R5.  The other side connect to the +5V supply.
This is used to reset the 8031 microcontroller. 

Have fun.

Jimbob




>    I have both PAIA VCF and VCA. I want to run these from a +-15V power
>supply. I am not an expert at electronics it appears to me that both of
>these modules use 12V regulators at the power supply. My question to you
>is can plug these modules into a 15V power supply without modification?

>--M

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20000424/83d62a5a/attachment.htm>