DIY PCB etching

[Hallgeir Helland]

Hi all,

I just successfully etched my very first (at home) PCB!
I used the ELFA kit including laminate, developer and
etching powder. And my home made UV exposer. (low cost)

Here's my question: The etching solution is best at 50 
degrees centigrade - on this first board I used hot tap
water, but now it has chilled. Can I heat it in the
microwave oven?? Or is that dangerous?

thanks,
Hallgeir
-- 
HELLAND MUSIKK TEKNOLOGI
-=  Hallgeir Helland  =-
hhelland at mailandnews.com