Seq2 Boards/ New Analog...

[tomg]

It seems I bought some clogged plumbing and a yard full
of ants (not the fire type!) so I was delayed a little by
the plumber and the critter-killers 

I picked up the boards today. As I was packing them up I 
noticed the mounting holes were not 1/8". Rather than hold
up shipping by taking them back, I figure you guys will have 
a drill in your hand at some point and you probably have a 
1/8" bit somewhere so...... here they come.

As I was packing the boards, watching si-fi and thinking 
about the "New" analog synth. I got this picture of a minimoog 
on a VLSI. Do you think it could be done and If you could do 
it...what would it cost?  What would you add? At what cost?

All parameters must be VC to do polys with. What would
you have to add? And how much support circuitry would it
take?

I'm thinking one chip lots of control lines, and a few caps.
Sure would be one hell of a chip. Please make me a few
samples....

-tg (dreaming in Atlanta)