Wire-wrap

[Paul Maddox]

Dear all,	

  My circuits seem to be getting more complex and strip-board
is fast becoming a pain in the arse to use... Im looking into
wire-wrap, can someone explain this to me and what I may need.

  From what Ive seen you solder a wire, run it to where its going
solder it, cut it (if needed) and start again.. I guess the heat
from the soldering iron melts the thin covering, what stops
the heat from one wire melt then outer of another and shorting
them?

  Paul

*********************************************************
*   Modulus Synthesiser DIY page ;-				*
*				www.xavax.com/modulus	*
*  Email ;-							*
*	  Paul.Maddox at unilever.com				*
*********************************************************