303 buttons and LEDs

[Dan Gendreau]

I bought my switches in the DigiKey catalog for $0.33 apiece. Part #SW413-ND
12mm tact switches with a 7.3mm raised square actuator.

> The caps on the switches will be a little loose. It
> will more than likely fix your prob.

They were actually too tight. I had to file the square actuators a bit with
an emory board to get them to fit. NOTE: Do this before you solder them in.
Its a lot less hassle.

As for the LEDs, I dont know the exact type, but I think they are T-1 3mm
LEDs. They should also have them in Digikey.

-Dan G.