press-n-peel: any experiences?

[Paul Perry]

At 08:59 AM 11/10/99 -0700, John Speth  wrote:

>I did have one problem: it seemed that as the iron was heating the film and 
>board, the film would actually expand more than the board so that it would 
>slip at the periphery of the part of the film that made the best contact. 

I think some people say, get a heatgun and 'pre-heat' the board, to I suppose 
'pre-expand' it. But, if you iron from the BACK of the PCB, then I suppose the
film and copper will heat up at the same rate. Not that I would expect PCB and
film to have anything like the same thermal coefficient of expansion.

(that 'pre-heat' trick might refer tothe 'other' toner system. I'm still 
collecting advice from everywhere, and still trying to find p'n'p in 
Australia)

thanks from Paul p-erry Melbourne Australia