AW: cross-point switches (was : PolyModular)

[Ullrich Peter]

	>  The problem I found with cross point switches is that when you turn on one 
	>'switch' or cross point, that the other in the row/column are turned off... 
	>this would make multiple routings impossible...
	>
	>  Unless there are new devices that dont do this?

	The Mitel MT8816 doesnot do this!
	It has 128 crosspoint switches - everyone has its own address.
	You just set the data line to 0 or 1 (open/closed) and that is it!
	And there is also a reset that resets all crosspoints.

	And the package is PLCC44 and not TQFP128 or so.

	Ciao
	Peter

        \|/
       (o o)
--oOOO--(_)--OOOo------------------------------------------------------
                   Ing. Peter Ullrich         mailto:ullrich at kapsch.net
                   Homepage: http://come.to/ullrich    or the full link
                   http://www.geocities.com/SiliconValley/Heights/3586/
                   Hardware & Software Developer /  Electronic Musician
   .oooO           KAPSCH AG / SGB2                    Vienna / Austria
   (   )   Oooo.            Traffic Control and Transmission Technology
----\ (----(   )-------------------------------------------------------
     \_)    ) /
           (_/