VCF/VCO pages fixed.

[tomg]

I fixed the vco4d page. How the hell did that happen? I guess
I uploaded the schematic 90o out. No one else could have done 
it.

I also updated the vcf2e page. I did the frac-rack/PDF layout over 
again, it now takes a 3 space but it's better. I added the 
ADSR mod and did some more work on the text and parts
list. This should be enough for most of you. I'll check in the
middle of the week sometime to see whats-up. Yes I'm 
taking the laptop. I plan to work on the vca and ms20 boards
at least a little. A guy can only take so much surf, sun and
fun then he must have his DIY.

I usually come back with a new to me kbd of some kind. Last
year I got a Poly61 for $75 two years ago I found a Poly800II
for $60. Of course it's all screwed up because of the sand, heat
and salt water but it's fun to restore. 

I'll check my mail once more before I go. If you have problems
or questions now is a good time.

-tg