Tube questions

[DCMagnuson at aol.com]

In a message dated 12/20/99 5:51:13 PM Eastern Standard Time, 
dougt at cancerboard.ab.ca writes:

> I am just beginning to build a dual VCA module for my tube 
>  percussion synth. The more that I think about it, the more 
>  that I feel that I would like to be able to patch signals 
>  between any section of any module. So I have decided to 
>  keep all signals in the range of less than +/-15 volts

Would there be any way to (cost effectively) have a switching matrix to route 
the modulation and signal paths?  It's been done in normal analog synths, why 
not a tube synth?  

You'd have the benefit of being able to leave the signals at full level, and 
avoid being killed making your patches... 

Just a thought

Dave Magnuson
Independent Music Site
http://www.indiemusicsite.com