AW: Sram

[Ullrich Peter]

	Hallo Paul!

	>  Im trying to find some SRAM with seperate input and output pins (dual 
	>port?). I need 2 lots of 24Bits (so it could 6 4bit chips, 3 8bit chips,etc) 
	>by 16 byte (not a lot I know), anything bigger would work.

	Why only separate data lines and not address lines too?
	If you only need seperate data lines it would be easier to take a normal sram
	and latches and buffers to seperate read/write data!

	>  Two problems I have found, most seems to be 32K (which is ok) but have 
	>seperate address lines for reading/writing and also seem to be PLCC, I would 
	>really like to stick with DIL, just so I can vero it easier.

	Normally seperate read/write data is not permitted as not needed in most cases.

	Can you tell me what you need it for? May be I can find a solution.

	Ciao
	Peter

        \|/
       (o o)
--oOOO--(_)--OOOo------------------------------------------------------
                   Ing. Peter Ullrich         mailto:ullrich at kapsch.net
                   Homepage: http://come.to/ullrich    or the full link
                   http://www.geocities.com/SiliconValley/Heights/3586/
                   Hardware & Software Developer /  Electronic Musician
   .oooO           KAPSCH AG / SGB2                    Vienna / Austria
   (   )   Oooo.            Traffic Control and Transmission Technology
----\ (----(   )-------------------------------------------------------
     \_)    ) /
           (_/