Newbie PCB ques..

[>>>marjan<<<]

> you take the artwork drawing, and stick it to the raw PCB.
> Then get a pointed punch, and ding wherever there is a hole.
> Then take off the artwork, and use a 'resist' pen to
> draw in the tracks. You cant go far wrong, as you have the dings to
> guide you.
> Then drill the holes & etch the board.
> 
> WARNING: I havn't tried this. But, for an uncrowded single side board,
> it looks likely.

It works, I made my old boards like that. I used "permanent marker"
for traces and ferichlorid for echant. Now, that's bad acid :(



marjan