mix resistor values...

[WeAreAs1 at aol.com]

In a message dated 8/10/99 12:21:55 PM, you wrote:

<<My question is....the CV's need to be mixed together (each of the eight 
steps per channel) and I was wondering...woulfd I be better off with 10k 
pots and 100k mix resistors into the amp or vice versa (ie 100K pots and 
10k resistors)?...Thanks for any advice....>>

It depends, to some extent, on the current drive of the CV source (and the 
desired gain of the following amp).  What is the initial source of the CV's?  
TTL or CMOS output?  Individual transistors?  4051 output channels?

For what it's worth, most commercial analog sequencers that I've seen use 50K 
linear pots.

Michael Bacich