Interest Jurgen's Scanning Interpolator PCB?

[JWBarlow at aol.com]

In a message dated 4/4/99 1:42:24 PM, jhaible at primus-online.de writes:

>If someone is going to make a layout for this, please make it for
>slider pots. 8 vertical slider pots, the LEDs below these,
>and the manual / CV input stuff below that.
>I would be interested in on of these pcbs as well. (Did I say
>I don't like standards ?? (:->) )

>BTW, I have a layout for the original one. It has at least one error,
>though: One of the reference voltage sources was just an opamp.
>But it has to provide more current, so I had to cut a few copper
>traces and wire an emitter follower inside the opamp's feedback loop.
>There may be other changes, too.

>Yes, I think it would be the best if someone would make a PCB with
>sliders for this module !

It seems as though several other "DIYers" would be interested in Jurgen's 
Scanning Interpolator PCB (and apparently, we have the designer's blessing?). 
Unfortunately, I'm not sure how we could make panels for sliders, anybody? 

I believe someone offered to make up PCBs(?), maybe this would be a good 
project to start with since it seems to have widespread appeal. Does anyone 
know how much a PCB run would cost roughly?

Now if I can get some people interested in Joachim's 40235 VCF.
JB