MOTM FracRack dimensions

[Paul Schreiber]

The MOTM panels are 0.025 SMALLER than John quoted to allow for "slop" in
manufacture. The corner
holes of overdrilled on purpose to allow the panels to "jiggle" in the rails
so you can fit them in tightly without
overlap.

Paul S.

-----Original Message-----
From: JWBarlow at aol.com <JWBarlow at aol.com>
To: 104065.2340 at compuserve.com <104065.2340 at compuserve.com>;
synth-diy at mailhost.bpa.nl <synth-diy at mailhost.bpa.nl>
Date: Saturday, April 03, 1999 7:09 PM
Subject: MOTM FracRack dimensions


>
>In a message dated 4/3/99 4:02:20 PM, 104065.2340 at compuserve.com writes:
>
>>Can someone tell me what the dimensions of the Fracrack and MOTM 5U panels
>>are?
>
>MOTM 5U panels are 8.75" high by 1.75" wide for a 1U wide panel. 2U panel
is
>3.5" wide, and the 3U panel is 5.25" wide. So 10 MOTM units will fit in a
>standard rack width.
>
>PAiA 3U FracRack modules are 5.25" high by 1.5" wide for 1U, 3" wide for a
>2U, and 4.5" wide for a 3U. There are some small end panels (like rack
ears)
>that are 2" wide. Again, 10 units wide will fit a standard rack.
>
>If that's not right, I'm sure Paul S. and John S. will correct me!
>John B.
>