PCB success!

[jorgen.bergfors at idg.se]

>>>Well, I wanted to show that there is a method that is very quick and
>>>reliable.
>>>You don't have to wait for films to return from the service bureau or 
a sunny
>>>day when you're not at work.

>>Of course not. My point was to compare and contrast our successful
>>experiences. For the most part, they're actually very similar. The 
>>biggest
>>snag in negative process IS getting that doggone negative.

>>>With my method, you can go from circuit idea to working module in a 
single
>>>day.

>Just a note - the Press-N-Peel toner transfer sheets let you
>go from circuit idea to layout (easytrax) to transfer (laser printer)
>to patterned copper (household iron) to etched board in under two hours.
>The ability to avoid film is an advantage, as is the ability to avoid
>presensitized boards. 

>I do this regularly.

How much does Press-N-Peel cost per board (100x160 mm)? Where can you buy it? 
It isn't available at my electronics supplier.
Didn't somebody say that some touching up was necessary with that method?

/Jorgen