Serge Knobs

[niklas.lindberg at enator.se]

Hi!

The Serge knobs can be seen at:
http://www.thomasregister.com/olc/daviesmolding/flutd-in.htm

They are the no 1900 ones. I guess STS orders them in customized format
from Davies as they say they can put any marking you like on the knobs.
Don't know what the minimum quantity would be, though...

Also I could bet my right arm that Buchla used the ones seen at:
http://www.thomasregister.com/olc/daviesmolding/inst-kno.htm

Numbers 1600 & 1610...what d'ya think?

/ Niklas
<~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~<
 >  Niklas Lindberg                                   >
<   Analogue Synths & Electronics Freak              <
 >                                                    >
<     "The availability of a certain patchcord       <
 >	    is inversely proportional to its need"         >
<                                                    <
 >       _                              Anonymus      >
<_______/ \   _______________________________________<
           \_/


> -----Original Message-----
> From:	Christopher MacDonald [SMTP:cmacdon at ix.netcom.com]
> Sent:	Thursday, September 10, 1998 6:28 PM
> To:	synth-diy at mailhost.bpa.nl
> Subject:	Serge Knobs
> 
> Hi All,
> 
> I ordered a few knobs from Mouser which looked to be like those used on
> Serge panels. They turned out to be exactly the same *except* that the
> Mouser knobs have no white indicator stripe on them.  Part number is
> 5164-1900 and the catalog says they are made by Harry Davies.  I have
> sent an email to Mouser asking if these knobs are available *with* the
> indicator mark but haven't heard back from them yet.
> 
> -Chris MacDonald