MOTM breadboards

[Paul Schreiber]

I have laid out a 'DIY' breadboard for building your own MOTM circuits using the same pcb form factor. It has 4
pot positions (spaced for the Spectrol pots in MOTM, but you can just solder wires in the holes), 8 switched jack
in/outs, the 4 pin MTA156 power header (supplied), and room for about 15 ICs. There are about 10 
uncommitted busses for connecting to +V, -V and ground. This is a single-sided board with silkscreen.

I'll be getting a quote for the price tomorrow. It has 1667 holes (!!) drilled it. If it's too expensive, I'll not get any.
SO.....if you think this would be a purchased item(s), please send private email for what is a reasonable price
and I'll see if it's worth doing.

As a PURE GUESS, I'd say I would sell them (pcb + power connector+ power cable) for around $25. It's all 
going to depend on what they charge me for all those holes!!!

Paul Schreiber
Synthesis Technology