Asm-1 Glide

[Andrew Schrock]

On Sun, 14 Jun 1998, tim0 [Timo Christ] wrote:

> Hi Synth-DIY!
> 
> I would like to put a Glide-Module into my synth, and i´d like to take
> the ASM-1 Glide module.
> 
> I´m sure it´s a simple thing (the asm-1 homepage tells so), but i need
> the schematic.
> 
> Please, proud ASM-1 owners, can you draw me a simple ascii-schematic of
> the glide - module ?
> 
> If desired, i will make a PS or GIF drawing and send it to the asm-1
> homepage so that it can be added to the schematics section.

Ok, I have a spare sec, so here it goes: (it's just 1 dual op-amp, 1 100k
pot hooked up like a variable resistor/rheostat, and a 1uF cap. Taken
right from Gene Stopp's photocopies included in the asm-1 packet) 

EXPONENTIAL: 

	    .--------.			  .--------.
	    | 2      |		   	  | 6	   |
	    .--|\ 1  |   "glide" 100k pot .--|\7   |
c/v in o-------| >---.---/\/\----------.-----| >---.-----o c/v out
	      3|/		       |    5|/
				       |
				      === 1uF cap (non-polarized)
				       |
  				      ___
				       _
				       .
LINEAR: (adds a 300ohm resistor, gets rid of 1 trace. now that I think
about it you could hook this up with a switch in case you're can't decide
between the two) 


	    .-------------------------------.--------.
	    | 2      		     	    | 6	     |
	    .--|\ 1 300ohm "glide" 100k pot .--|\7   |
c/v in o-------| >---/\/\---/\/\---------.-----| >---.-----o c/v out
	      3|/		       |      5|/
				       |
				      === 1uF cap (non-polarized)
				       |
  				      ___
				       _
				       .


Andrew