vectorboards?

[tim0 [Timo Christ]]

Moin DIY,

Paul Perry wrote:
> A quick and dirty but very reliable way used successfully by synth and even
> RF people is to build everything on the copper side of raw PCB and cut traces

hey, cool! i kinda re-invented that, i thought this way of doing it was
so ridiculous nobody beside me would do it .. :-) 
i see problems cutting the little traces between IC pins..

> out with an engraving tool, or just paint with nailvarnish and etch.. again,

i guess you get a particularly optically pleasing board with the
nailvarnish .. %,)

> paul perry melbourne australia
again! 

see ya, 
Timo
-- 
+----------------------------------------------+  ___ 
!tic at vossnet.de - Timo Christ, Germany         ! (__  |__| |
!http://pages.vossnet.de/tic/                  ! ___) |  | |___
+----------------------------------------------+