vectorboards?

[|[| Philip Pilgrim |]|]

Tony Clark wrote:

>    My main trick is to route as much of the traces as possible without
> using wire to jump from one point to another.  What I do is take
> component lead clippings and start soldering them from pad to pad and
> snake them around the board until they connect to where I want them to
> go.  

Wow that is a great idea! I was wondering how to make use of the vast
landscape on these bigger boards (only the smaller ones seem to have the
three hole pads).

I think I will use bus-wire rather than clippings to route around the
board. Bus wire is just wire with no insulation.

Philip
-- 
Philip Pilgrim          	The Lab 
5 Evan's Drive          	- Analog/Digital Recording/Processing
Hammonds Plains       		- Computer/Synth Interfacing
Nova Scotia, Canada   		- Hardware/Software Development
B4B 1M8                   

   <<<<< Home of SH-101 NovaMod and UP Midi Programmer
>>>>>                     

Phone     +1.902.835.7844
Email     mailto:thelab at sprint.ca
Web Page: http://www.robotnik.com/the_lab/