Rack mounted filter PCBs

[Tony Allgood]

Hi folks,

I have just been quoted for the PCBs for the rack mounted Moog filter at the
archive, address below. To cover costs the PCBs will be about 27UKP each
plus any postage. All pots and switches are PCB mounted, the board being 90
degrees to the front panel. The only wires will be for the input and output
jacks. These will have to be rear mounted if the case used is 1U high. A
front panel layout will be posted to those interested. The PCB is double
sided with component legends on top side. ALPS min pots are specified but
most miniature pots should fit. The hole spacing is on a 0.2''/5mm pitch. I
have used Sansai Sub-min push switches to implement the switch functions,
similar to ALPS and others. These are stocked by Maplin in the UK.
Alternatively, off-board interconnects can be made to any switch of your
choice.

Mail me by private e-mail if you are interested in purchasing. I will only
order the PCBs if more than ten of you want one. NRE costs and so on.

Regards,

Tony Allgood, Cumbria, UK

e-mail: oakley at enterprise.net

My latest project; a rack mounted VCF module with warmth. See it at:

http://aupe.phys.andrews.edu/diy_archive/schematics/effects/filter.html